- Message from the Co-Chairmen
- ADHD: Common among Kids, Adults
- January is Glaucoma Awareness Month
- Economic Recovery May Spur On-the-Job Injuries
- Proposed Silica Standard Needs Stronger 'Competent Person' Requirement
- Giving Effective Toolbox Talks
- Work Zone Intrusions Threaten Safety
- Is Your House a Hazard to Your Health?
- Universal Drill Jig Adapted for Commercial Building Construction
- Healthier Alternatives to Increase Energy
- Feeling Out of Sorts? Maybe It's Your Thyroid
Universal Drill Jig Adapted for Commercial Building Construction
For the past four years, Dr. David Rempel and development engineer Alan Barr have worked to design a universal drill jig that can relieve construction workers from the extreme physical stresses endured during concrete and rock drilling (see New Device Takes Strain Out of Overhead Drilling).
Tunnel construction and necessary seismic upgrades of large buildings have created significant demand for such drilling on the West Coast. Rempel and Barr, based respectively at UC-San Francisco and UC-Berkeley, met the challenge with successive versions of their new device, which reduces the fatigue associated with drilling hundreds of dowel holes in concrete with a heavy, hand-held pneumatic or hammer drill. Early versions of the jig were tested and evaluated at the Terence J. O'Sullivan Laborers' Training Center in San Ramon.
Improvements spur wider use
In 2012, the UCSF team tested different versions of the jig on construction sites across the Bay Area. Worker and contractor feedback informed important improvements:
- A universal saddle that accepts large electric hammer drills and pneumatic rock hammers
- A more reliable remote on-off switch
- A new design that allows the drilling arm to be set to any drilling angle, without cumbersome removal and resetting of bolts, thereby reducing bending and reaching during drilling
- A new bearing system that makes the jig easier to use and more robust
- A drill saddle design that allows using two drills simultaneously
Now, the jig is gaining fans across the country. Massachusetts Electric Construction is using ten rigs, each bearing two drills, on a year-long tunnel project in Chicago. McCarthy Construction, a commercial building contractor, is using ten rigs on an eight-story renovation in San Francisco. The project involves drilling more than 20,000 holes over a three-month period; the jigs in use speed work by drilling two perfectly spaced holes simultaneously.
Silica hazard addressed
Equally important, Rempel and Barr have enlisted the drill jig in the war against silica hazards. Tasks like dowel drilling and overhead or lateral drilling in rock or concrete can generate significant amounts of dangerous airborne crystalline silica. Workers who inhale the particles are vulnerable to silicosis and related respiratory problems, an occupational health concern severe enough that OSHA has proposed a new rule requiring more stringent workplace controls.
To combat this scourge, Rempel and Barr have incorporated a new dust capture system on the drill. Dust control is achieved by one of two methods; the most common is a dust shroud over the bit that attaches to the jig. A new innovation from Hilti, using a hollow bit with a vacuum port, was deployed on the McCarthy project. The vacuums are mounted on the jig for ease of movement.
- Using feedback from laborers and electricians who used the jig, the team improved its design with a universal drill saddle, an improved remote on/off switch and a new method for rapidly adjusting drilling height and angle.
- Bay Area contractors have put the drilling jigs to use on seven commercial construction sites, including a seismic retrofit of the Bay Area Rapid Transit (BART) towers.
- New drill jig heads allow the option of drilling two holes simultaneously – one contractor successfully used the dual drill jig to install miles of electrical conduit in a tunnel in half the expected time.
- The team has presented findings to four national and local contractors’ health and safety meetings, three union health and safety meetings, six scientific conferences and in an article published in the Journal of Occupational and Environmental Hygiene.
- A local manufacturer, Ergomek.com, is now producing a commercial version of the jig called the DrillBoss.